Working off the earlier development of adjusting surface area based on wall alignment to the wind, I multiplied the logic for 2×2ft panels. Removing the manual adjustment sliders, the rotation angle is now based on the distance from a fixed point (in this case the road). By adding a multiplier to the distance I was able to have further control over the scale ratio between rotation angle and distance.
I tried making the road the point that moves, but for some reason grasshopper logic went all screwy depending on which point plugged into ‘A’ and which to ‘B’. Essentially the whole thing wouldn’t work if I flipped the line direction of association (wall to road vs. road to wall) – couldn’t figure out why.
Next iteration will be to have diameter of openings adjust along a fixed wall. Bambalamb. Files on network as ‘ratio wall’.
